欧美成人三级_九色在线视频_视频一区在线播放_亚洲一级一级97网_亚洲最大的免费视频网站_幼a在线观看_国产美女av

編輯此資訊 : How To Repair Denso Common Rail Injector-1

推廣資訊

分類目錄: *

信息類型: *

公司庫品牌庫產品庫供應信息求購信息服務項目解決方案業界資訊新聞事件展會情報名詞解釋知識庫文章招聘信息網址連接圖片庫資料下載創業加盟招商合作促銷活動其它信息

標題: *

詳細內容: *

At present, the technical and maintenance information of Denso common rail injectors is widely used and existing in the global diesel market. The following document aims to provide a guide to using the tooling and shim kits together with genuine and non-genuine parts, to strip, rebuild and test Denso ‘G2’ type common rail injectors. Alterations to the shim adjustment of individual injectors were made and the results recorded. These results have been used to determine what effects any changes to the shim adjustment have on the overall performance of the injector. Correction codes (QR codes) cannot be written and produced for any Denso injector using this information. The production and creation of QR codes requires complex software and intricate flow testing using genuine Denso/Hartridge authorised equipment. Denso Common Rail injector repair involves stringent clean room practices and very tight quality control on build tolerances. Please take this into consideration when attempting any dismantling of Denso Common Rail injectors. Hopefully this guide will provide an insight into what can be achieved with tooling available outside of the Denso official repair programme. Consideration should be given to the importance of correction codes when undertaking any adjustment or unofficial repair of ANY common rail injector that uses a correction code. Component Overview and Identification: The photo below shows an exploded stripped Denso G2 injector and labelled components: Dismantling The following dismantling, rebuild and test instructions are based on the use of the Common Rail injector kit (part number- 850901) and Shim Kits (850276, 850296, 850301) available to purchase from Diesel Distributors, together with genuine and non genuine repair parts. STEP 1 – Solenoid Removal Mount the injector upright in the vice using the correct holding jaws, depending upon the body type and using the 27mm ‘crow’s foot’ gently loosen the solenoid (fig 1). Once loose continue to loosen by hand and CAREFULLY and GENTLY remove the solenoid, taking care not to drop the solenoid valve spring or tensioning shim (Fig 2). Remove the ‘fuel calibration shim’ that will either still be sat on the injector or sat up inside the solenoid body (Fig 2). The solenoid valve can then be removed using long nose pliers. TAKE CARE NOT TO DROP THE ‘HALF BALL VALVE’(Fig 3). This is situated in the end of the solenoid valve. It is small and very easily lost!! -(Replacement valves and half ball valves are available through Diesel Distributors). https://www.cntestbench.com/

上傳圖片:

* (jpg , gif , png) format

聯繫人信息

姓名: *

電子信箱: *

手機:

公司名稱:

聯繫電話:

詳細地址:

郵遞區號:

網址URL:

其他

關鍵字:

有效期:

* 天

管理密碼:*

* 刪除/修改

更換密碼:

* 如有必要，可重新設置新的管理密碼

刪除此資訊

*